#OSHA LOADING DOCK SAFETY CHECKLIST DRIVER#
#OSHA LOADING DOCK SAFETY CHECKLIST PORTABLE#

#OSHA LOADING DOCK SAFETY CHECKLIST PORTABLE#

Except when maneuvering at a very low speed, the hand steering wheel shall be turned at a moderate, even rate.įederal OSHA does not specifically require employers to equip forklifts with portable fire extinguishers. 1910.178(n)(15) - While negotiating turns, speed shall be reduced to a safe level by means of turning the hand steering wheel in a smooth, sweeping motion.

#OSHA LOADING DOCK SAFETY CHECKLIST DRIVER#

1910.178(n)(10) - The driver shall be required to slow down for wet and slippery floors.1910.178(n)(8) - Under all travel conditions the truck shall be operated at a speed that will permit it to be brought to a stop in a safe manner.1910.178(n)(7) - Grades shall be ascended or descended slowly.If the load being carried obstructs forward view, the driver shall be required to travel with the load trailing. 1910.178(n)(4) - The driver shall be required to slow down and sound the horn at cross aisles and other locations where vision is obstructed.A safe distance shall be maintained approximately three truck lengths from the truck ahead, and the truck shall be kept under control at all times. 1910.178(n)(1) - All traffic regulations shall be observed, including authorized plant speed limits.Otherwise, the OSHA regulation addresses speeds in a few places, in a general manner: This information, along with other factors, can then be used to calculate a maximum safe speed. For example, paragraph 4.3.2 of ASME B56.1 contains a Stopping Distance formula which may be useful in determining approximate theoretical stopping distances where certain variables are known. For additional assistance in determining safe travel speeds, OSHA says an employer could look to consensus standards such as ASME B56.1 Safety Standard For Low Lift and High Lift Trucks. While specific speed limits are not available, OSHA has said it would consider the totality of the circumstances surrounding the operation of the powered industrial truck in determining whether safe travel speeds are practiced at a workplace. These factors include, but are not limited to, the type of truck, the manufacturer's limitations on the truck, the load being carried, adequate stopping distances, operating surface conditions, pedestrian traffic, and other safety issues. However, in determining what is a safe speed, OSHA would take a variety of factors into consideration. OSHA does not have specific speed limits set for the safe operation of a powered industrial truck. Our deep knowledge of federal and state agencies is built on a strong foundation of 70+ years of regulatory compliance experience. You can trust our expertise across subjects relating to labor, transportation, environmental, and worker safety.

Osha loading dock safety checklist